Heater Controller

Dual Aquarium Heater Controller

The IceCap heater controller can connect up to two heating elements (sold separately) and provides precise temperature control for an aquarium. It includes dual-heating power jacks and supports up to 1000 watts. For added safety, you can use it in conjunction with an aquarium system controller.

Features:

• Dual grounded output heater control
• Accommodates a combined total of 1000 watts
• Accurate heat control
• For freshwater and marine aquariums
• 1-year limited warranty

Specifications:

• Temperature Control Modes: On/Off Control, Heating
• Temperature Control Range: 20-34°C / 68-93°F
• Temperature Resolution: 0.1°C / 32°F
• Temperature Accuracy: ±1°C / ±1°F
• Ambient Temperature: <35°C / 95°F
• Audible Alarm: Over Temperature Alarm
• Input Power: 100 ~240VAC/60Hz
• Relay Contact Capacity: Heating (10A, 100-240VAC)
• Controller Body Dimensions: 3.125in x 5.375in x 1.125in (LxWxH)
• Probe Cord Length: 5ft
• Heater Outlet Cord Length: 18in
• Calibration Offset: ± 5.0° (C/F) in 0.5° increments

Heater controller only - Requires a proper-sized heater(s) to operate.

For Indoor use only

Button Functions

	Hold and press the SET button for 5 sec. to switch the Controller ON or OFF. Press SET button once to enter the target temperature setting mode.
	Press the C/F button to switch the display between Celsius and Fahrenheit.
	Press the (+) button to increase the Target Temperature and press the SET button to save your setting.
	Press the (-) button to decrease the Target Temperature and press the SET button to save your setting.

Controller Temperature Calibration

Check the aquarium's water temperature on the thermometer against the temperature shown on the Heater Controller. If there is a large difference between the thermometer and the Heater Controller, you must calibrate it.

1. Press and hold (+) and (-) buttons simultaneously for around 3 seconds. The Water Temp display will begin blinking. The original allowance value shows at 0.0.
2. Press (+) or (-) button to adjust up or down the value ± 5.0° (C/F) in 0.5° increments
3. Finally, press the Set button to confirm calibration setting. The bottom display will change back to show the water temperature